Wymagane elementy:

• Upper illumination deck
• 2 washers
• 2 Allen screws ⌀ 4 mm.
• 1 hex key ⌀ 4 mm. (not provided)
• 1 hex key ⌀ 5 mm. (not provided)

1. Remove the screws securing the adapter;





2. Lift up completely the adapter-holder plate;





3. Unscrew the Allen screws from the top plate of the frame, using a hex key.
   Notka: Use a hex key ⌀ 5 or ⌀ 4 depending on the screws on the frame.





4. Remove the top plate from the frame;





5. Set the upper illumination deck, aligning the mounting holes;
6. Set a washer for each hole, making sure to keep the countersunk side of the washer upwards;





7. Tighten the Allen screws on the upper illumination deck, using the hex key ⌀ 4.
   Notka: The washer must be placed over the red/black power cord.





8. Lower the adapter-holder plate;
9. Screw back the screws securing the adapter.

1. Ustaw ECU na ramie pozycjonującej;
2. Ustaw adapter into the compartment of the frame;
3. Solder one or more solder wires on the programming pads and ease them into the connector of the adapter to be used, following the connection instructions provided in the manual of the family in use;
4. Lower the adapter on the ECU.

1. Ustaw ECU na ramie pozycjonującej;
2. Ustaw adapter into the compartment of the frame;
3. Place one or more programming probes on the programming pads, following the connection instructions provided in the manual of the family in use;





4. Wedge the programming probe under the deck;





5. Ease the wire of the probe into the connector of the adapter in use;





6. Lower the adapter on the ECU.