Bosch EDC16+ 002

On this type of ECU you can make reading and programming in two different ways:
- direct connection to the ECU using the flat cable 144300T100 some strips to be soldered
- using the positioning frame 14P800ADBO, the flat cable 144300T100 and the special board 14AM00T01M

Flat Cable 144300T100

Rama pozycjonująca 14P800ADBO, flat cable 144300T100 and special board 14AM00T01M

Before programming, we suggest you make a backup copy of the ECU.

1. Wyjmij ECU z pojazdu;
2. Open the ECU, taking care not to damage the parts on the inside;
3. Ponownie podłącz ECU do pojazdu i uruchom silnik, aby upewnić się, że nadal działa i nie został uszkodzony podczas otwierania;
4. Ponownie wyjmij ECU z pojazdu;
5. Select the right family;
6. Make the backup of the data on the ECU.

Okno kopii zapasowej of a Master Tool

The programming pins are in the lower part of the back of the ECU. To reach these pins you must remove completely the PCB (front and back) from the metal cover. OSTRZEŻENIE: the ECU is glued to the cover. The removing operation must be done with great care to avoid damaging the ECU.

Połączenie bezpośrednie to the ECU

1. Solder the strips to the programming pins, starting from the left:
   
   
   
2. Connect the flat cable to the strips soldered on the ECU. Keep the colored stripe of the flat cable to the left, as pokazanego na zdjęciu:
   
   
   
3. Proceed with the reading or programming.

Połączenie z ramą pozycjonującą

1. Put the ECU in the positioning frame;
2. Place the special board 14AM00T01M into the compartment;
3. Connect the flat cable 144300T100 to the special board;
4. Connect the other end of the flat cable to the tool;
5. Lower the special board on programming pins as pokazanego na zdjęciu:
   
   
   
   
6. Proceed with the reading or programming.