Protokół numer 457

• How to Read (click here for more information)
  1. Connect the tool to your computer;
  2. Connect to the Gearbox ECU using the DSG cable 144300K259:
     DSG 16-pin cable for TEMIC DQ500 ECUs
     144300K259
     
     
     
  3. Attach the alligator clips of the cable to the vehicle battery or a regulated power supply.
     Note: If the red LED on the cable switch is not lit, the ECU is not getting power. Check the power source and make sure you have properly connected the clamps.
  4. Read the gearbox ECU. Note: When asked to turn the ignition switch to on/off, act on the switch of the DSG cable.

  ---



• How to Write (click here for more information)

  ♦ Writing/Getting ID info with a DSG cable (click here for more information)

  1. Connect the tool to your computer;
  2. Connect to the Gearbox ECU using the DSG cable 144300K259:
     DSG 16-pin cable for TEMIC DQ500 ECUs
     144300K259
     
     
     
  3. Attach the alligator clips of the cable to the vehicle battery or a regulated power supply.
     Note: If the red LED on the cable switch is not lit, the ECU is not getting power. Check the power source and make sure you have properly connected the clamps.
  4. Read the gearbox ECU. Note: When asked to turn the ignition switch to on/off, act on the switch of the DSG cable.

  ♦ Writing/Getting ID info with Standardowy kabel OBD2 (click here for more information)

  1. Connect to the vehicle's diagnostic socket using the OBDII Standard cable 144300KCAN;
  2. Get the ID info or Write the gearbox ECU.